Preparation and Optical Limiting Properties of Polyurethane Containing Long Conjugated Chromophores

Two functional polyurethanes (P1 and P2) bearing a large π electron conjugated chromophoric pendant were synthesized and characterized by FT‐IR, ¹H‐NMR and UV‐Vis absorption spectra. Their optical limiting properties were evaluated. The results show that P1 and P2 show novel optical limiting properties, which are assigned to a long π electron conjugated chromophoric pendant. It was found that their optical limiting properties were affected simultaneously by solution concentration and P2 displays a better optical limiting property than P1 at the same solution transmittance, although that P1 has larger χ⁽³⁾ (4.28×10^?11 esu) than P2 (0.87×10^?11 esu), and their optical limiting mechanism is investigated.     

Determination of limonin in dog plasma by liquid chromatography–tandem mass spectrometry and its application to a pharmacokinetic study

A highly sensitive liquid chromatography–tandem mass spectrometry method was developed and validated for the determination of limonin in beagle dog plasma using nimodipine as internal standard. The analyte and internal standard (IS) were extracted with ether followed by a rapid isocratic elution with 10 mm ammonium acetate buffer–methanol (26:74, v/v) on a C₁₈ column (150 × 2.1 mm i.d.) and subsequent analysis by mass spectrometry in the multiple reaction monitoring mode. The precursor to product ion transitions of m/z 469.4 → 229.3 and m/z 417.2 → 122.0 were used to measure the analyte and the IS. The assay was linear over the concentration range of 0.625–100 ng/mL for limonin in dog plasma. The lower limit of quantification was 0.312 ng/mL and the extraction recovery was >90.4% for limonin. The inter‐ and intra‐day precision of the method at three concentrations was less than 9.9%. The method was successfully applied to pharmacokinetic study of limonin in dogs. Copyright © 2012 John Wiley & Sons, Ltd.     

延误休假且修理延迟的可修系统的更换策略

研究了修理工多重延误休假且修理延迟的可修系统,假设系统故障后均不能"修复如新",系统在准备休假期间故障的概率为q,系统延迟修理的概率为1-P,以系统故障次数为更换策略,运用更新过程和几何过程理论,得出系统长期运行单位时间内平均停机时间的表达式,并通过数值例子验证了存在最优策略,使得平均停机时间最短.     

4106航空润滑油拖动特性研究

采用高速球-盘式拖动力试验装置测定了4106航空润滑油在不同载荷、滚动速度、入口油温及滑滚比下的拖动系数,分析了润滑油的拖动特性,建立了拖动系数的简单计算公式.结果表明:4106航空润滑油的拖动系数随着载荷变化出现转折;在高速和高压条件下,4106航空润滑油呈现非牛顿特性;当入口油温较低时润滑油的热效应较显著;随着载荷增大,入口油温和滚动速度对拖动系数的影响减小;理论计算结果同实测值吻合良好.     

溅射功率对脉冲磁控溅射沉积Cu2O薄膜结构和光学性能的影响

利用脉冲磁控溅射制备技术,采用单质金属铜靶作为溅射靶,在氧气(O2)和氩气(Ar)的混合气氛下,在石英玻璃衬底上制备了Cu2O薄膜.研究了溅射功率对脉冲反应磁控溅射沉积法在室温下对生长Cu2O薄膜结构、表面形貌及光学性能的影响.结果表明,在O2、Ar流量比(O2/Ar)为30∶80的气氛条件下,在60～90 W的溅射功率范围内可获得＜ 111＞取向的Cu2O薄膜;薄膜的表面粗糙度的均方根值随溅射功率的增加而增大;薄膜的光谱吸收范围为300 ～670 nm,不同溅射功率下制备的薄膜均在430 nm附近出现明显的带边吸收,其光学带隙(Eg)在2.15～2.53 eV之间变化.     

炼铝工业固体废料(赤泥)的物质组成与工程特性及其防治利用研究

据保守估算 ,我国每年排放的铝工业固体废料赤泥至少在 5 0 0万 t以上。由于赤泥对生态环境的严重危害 ,赤泥坝、赤泥库的安全已成为令人关注的环境问题。各类固体废弃物 (包括生活垃圾 )储存、处理和利用的研究不仅是当代环境科学的重要任务 ,亦是当代环境工程地质学、环境岩土工程学最重要、最迫切的研究任务之一。本文利用工程岩土学的有关理论和方法 ,系统地研究了赤泥的化学、矿物成分、不良工程特性及其形成变化机理 ,并在此基础上提出了赤泥的储存、加固 (处理 )和综合利用的原理和途径。     

抗压桩与抗拔桩侧阻的研究

对抗压桩和抗拔桩的桩侧摩阻力进行了理论探讨 ,从定量上考虑了桩周土的剪胀性及主应力方向旋转对侧阻的影响 ,得到了相应的影响系数和侧阻的预测公式.     

消除预脉冲电压的撬棒管开关法

 分析了脉冲线加速器在放电过程中产生的预脉冲电压现象。为了减少预脉冲电压引起的等离子体发射对正常状态的影响，采用了一种冷阴极撬棒管，将它与阴极杆相连。实验证明在采用了这种器件后，预脉冲电压可以从150kV左右减少到50kV。相对论返波管和相对论磁控管的性能得以显著改善。     

One‐Electron Oxidation of [M(PtBu3)2] (M=Pd,Pt): Isolation of Monomeric [Pd(PtBu3)2]+ and Redox‐Promoted C−H Bond Cyclometalation

Oxidation of zero‐valent phosphine complexes [M(P^tBu₃)₂] (M=Pd, Pt) has been investigated in 1,2‐difluorobenzene solution using cyclic voltammetry and subsequently using the ferrocenium cation as a chemical redox agent. In the case of palladium, a mononuclear paramagnetic Pd^I derivative was readily isolated from solution and fully characterized (EPR, X‐ray crystallography). While in situ electrochemical measurements are consistent with initial one‐electron oxidation, the heavier congener undergoes C−H bond cyclometalation and ultimately affords the 14 valence‐electron Pt^II complex [Pt(κ²_PC‐P^tBu₂CMe₂CH₂)(P^tBu₃)]⁺ with concomitant formation of [Pt(P^tBu₃)₂H]⁺.     

绝缘栅双极晶体管固体开关技术研究

 采用二只1.2kV,75A的绝缘栅双极晶体管（IGBT）串联，对用于加速器的IGBT固体开关技术进行了研究；通过采取动态电压和静态电压平衡措施来解决IGBT串联中的瞬态电压平衡问题。在不同工作条件下，串联IGBT开关工作性能稳定，重复性好。在纯阻性负载上得到了上升时间约300ns、下降时间约164μs、峰值电压1.8kV的输出。